Light-activated acid drives energy-efficient, on-demand release of captured carbon dioxide

On-demand CO2 release under ambient conditions using light instead of heat is achieved for simulated and amino acid-based direct air capture systems by regulating solution pHs via a photoinduced proton transfer of a reversible metastable-state photoacid, leading to energetically sustainable and economically feasible climate change mitigation solutions using solar energy. Credit: Angewandte Chemie International Edition (2023). DOI: 10.1002/anie.202304957

Using light instead of heat, researchers at the Department of Energy’s Oak Ridge National Laboratory have found a new way to release carbon dioxide (CO2) from a solvent used in direct air capture, or DAC, to trap this greenhouse gas. The novel approach paves the way for economically viable separation of CO2 from the atmosphere.

The on-demand release of carbon dioxide is possible because the long-lived excited state of a novel acid controls the solution’s proton concentration using ultraviolet light, creating conditions that lead to CO2‘s energy-efficient release. By contrast, current DAC technologies filter air through an aqueous solution containing a sorbent material, such as an amino acid, that takes up atmospheric CO2 and holds it. Heating the solvent releases the CO2 and regenerates the amino acid for recycling. The CO2 can be either stored or converted into value-added products, such as ethanol, polymers or concrete.

“In the existing direct-air-capture technologies, CO2 release and sorbent regeneration are the most energy-intensive steps,” said ORNL chemist Yingzhong Ma, who led the study published in Angewandte Chemie International Edition with ORNL colleagues Radu Custelcean and Uvinduni Premadasa, both chemists. “The goal here is to use the amino acid sorbent, which is recyclable and has a lot of attractive properties, combined with a more energy-efficient approach to release the CO2 and regenerate the sorbent.”

The National Academy of Sciences has concluded that DAC technologies have a role in removing billions of tons of CO2 from the atmosphere annually to help limit the rise in average global temperature to less than 2 degrees Celsius (about 4 degrees Fahrenheit). However, the intensive energy cost associated with sorbent regeneration and CO2 release at a scale that would mitigate climate change makes such a massive deployment a grand challenge necessitating the development of new DAC processes. The ORNL-led approach provided a proof of concept for using irradiation with ultraviolet light under ambient conditions instead of heating the solution to release the CO2 and regenerate the sorbent.

“Heating aqueous solutions is a common regeneration method, but it is extremely energy intensive,” said Custelcean, a pioneer in DAC. “We wanted to take heat out of the equation.”

Custelcean led a study in 2017 that proved a guanidine sorbent could directly capture CO2 from air. In 2018, he and colleagues demonstrated a practical, energy-efficient DAC method using solar heat to drive the release of the greenhouse gas from an amino-acid sorbent. This year, Knoxville-based startup Holocene licensed the technology to prepare it for industrial deployment.

In this new development, the key to releasing CO2 at ambient conditions is a photoacid, which is a molecule that becomes more acidic when it absorbs light. Shine a light on an acid such as vinegar and nothing happens. By contrast, expose a photoacid to ultraviolet or visible light, and a chemical group in the middle of the acid rotates from the opposite side of a bond to the same side. A subsequent reaction forms a ring, leading to transfer of a proton, or hydrogen ion, to the water solvent.

This transfer dramatically increases the acidity of the solution, producing a change called a “pH swing.” The excess protons can now interact with bicarbonate, or HCO3, which was made when CO2 reacted with the sorbent. The bicarbonate accepts a proton to become carbonic acid, or H2CO3, which is just one energetically favorable step away from carbon dioxide and water.

“This paper describes the first time where the macroscopic pH swing lasting from minutes to hours has been demonstrated using light as an external trigger to initiate the CO2 regeneration reaction,” said Vyacheslav “Slava” Bryantsev, leader of ORNL’s Chemical Separations group and a co-author of the paper.

“You can easily turn light on and off to control the reaction reversibly,” Ma said. “You can capture CO2 in the dark and then simply turn on the light when you want to release CO2 for storage or for making value-added products. It gives you a way to easily control the process on demand.”

That said, the researchers needed an additional trick of the light. Conventional photoacids would not work because the lifetimes of their excited states are very short—mere nanoseconds. They lose protons but then stay mostly in the same configuration. “Then you only change the acidity for a short time,” Bryantsev said.

Ma and Custelcean, who conceived the idea of using a photoacid to trigger CO2 release in DAC applications, ran into this problem when they began experiments using a commercially available photoacid.







Using light instead of heat, researchers at the Department of Energy’s Oak Ridge National Laboratory have found a new way to release carbon dioxide, or CO2, from a solvent used in direct air capture, or DAC, to trap this greenhouse gas. The novel approach paves the way for economically viable separation of CO2 from the atmosphere.</p><p>Amino acid sorbents (S) in water can capture carbon dioxide (CO2) directly from the air. The amine group reacts with CO2 to form a mixture of chemicals including bicarbonate (HCO3-). Researchers added a photoacid (PA) to this mixture. When the reaction chamber was exposed to light, the photoacid underwent structural changes and transferred a proton to the water. These events make the mixture more acidic and shifted its balance to produce more carbonic acid (H2CO3), which is unstable and at room temperature easily turns into CO2 and water. When the reaction chamber is covered to block the light, the photoacid returns to its initial protonated form (the trans configuration) and amino acids are now ready (deprotonated) for the next cycle of CO2 capture. Credit: Jacquelyn DeMink/ORNL, U.S. Dept. of Energy

“When carbonic acid decomposes, it has a short lifetime in water, on the order of a few seconds. But that’s an infinity compared to the lifetime of a regular photoacid, which is nanoseconds, or billionths of seconds,” Custelcean said. “That’s why you cannot do this chemistry with a regular photoacid: It takes seconds to release CO2 from carbonic acid, but it takes only nanoseconds for the photoacid to take the proton back.”

Bryantsev came up with the idea to try a different class of photoacid with a long-lived excited state. Called a metastable-state photoacid, it has a structure that persists in solution from seconds to hours. That means the pH change driven by the photoacid’s structural change also lasts a lot longer.

The scientists invited an expert in photoacid design and synthesis to join the team. Florida Institute of Technology’s Yi Liao had pioneered the new class of metastable-state photoacids around 2015 but for purposes other than DAC.

“We really made a breakthrough after we got this photoacid from our collaborator,” Ma said.

Custelcean agreed. “Having a metastable-state photoacid gave us plenty of time to release the proton and form the carbonic acid. Then the carbonic acid had time to release the CO2 in water. Once that happens, CO2 leaves the solution,” he said.

With Ma, first author Premadasa designed and conducted the experiments for the proof-of-concept study using a metastable-state photoacid synthesized by Liao and Florida Tech colleague Adnan Elgattar, with subsequent spectroscopic characterization by ORNL’s Benjamin Doughty and Vera Bocharova.

“Once we baselined the photochemical properties of the acid itself, our next step was to test its applicability for CO2 release with various DAC sorbents,” Premadasa said. “We can easily manipulate chemical compositions and intensities and colors of light to drive the photoreaction for efficient CO2 release.”

Audrey Miles from the University of Notre Dame and Stella Belony from the University of Florida, who were DOE Science Undergraduate Laboratory Internships students at the time of the study, tested the photoacid under different conditions for its CO2-releasing abilities. Then ORNL’s Michelle Kidder, Diana Stamberga and Joshua Damron measured the amount of CO2 released under those different conditions.

Many challenges remain to develop ORNL’s light-activated DAC technology. One is understanding the dynamics by which the photoacid forms a chemical complex with the amino acid sorbent. Another is improving the solubility of compounds in water. Yet another is optimizing the absorption of light from the visible spectrum. Moreover, the scientists would like to decrease the time required to regenerate the photoacid and improve understanding of its long-term stability.

Regardless, the future is bright for metastable-state photoacids. “Our study paves the way towards photochemically driven approaches for CO2 release and sorbent regeneration using solar light,” Premadasa said.

The title of the paper is “Photochemically-Driven CO2 Release Using a Metastable-State Photoacid for Energy Efficient Direct Air Capture.”

More information:
Uvinduni I. Premadasa et al, Photochemically‐Driven CO2 Release Using a Metastable‐State Photoacid for Energy Efficient Direct Air Capture, Angewandte Chemie International Edition (2023). DOI: 10.1002/anie.202304957

Provided by
Oak Ridge National Laboratory

Citation:
Light-activated acid drives energy-efficient, on-demand release of captured carbon dioxide (2023, September 28)
retrieved 29 September 2023
from https://techxplore.com/news/2023-09-light-activated-acid-energy-efficient-on-demand-captured.html

This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no
part may be reproduced without the written permission. The content is provided for information purposes only.

Share with your friends!

Leave a Reply

Your email address will not be published. Required fields are marked *

Get the latest technology news and updates

STRAIGHT TO YOUR INBOX

Thank you for subscribing.

Something went wrong.

x  Powerful Protection for WordPress, from Shield Security
This Site Is Protected By
Shield Security